The S:6 Testing Protocol, Part 2:

The S:6 Testing Protocol, Part 2:

  • October 30, 2017
  • Blog

In my previous post (The S:6 Testing Protocol, Part 1) I talked about the importance of testing to track the progress of your training. Through testing we look to see improvements in power outputs at specific interval durations over 6-12 weeks between testing. I explained how we prefer to test over FOUR different durations:

  • One longer one at a specific sub-maximal aerobic heart-rate, to identify Aerobic function
  • Three shorter maximal efforts to identify ones Anaerobic Power.

I also introduced the concept of identifying your Fatigue Rate. This sheds light on where your aerobic fitness, or endurance, is compared to your top-end strength/power. With this data, we can then track improvements in power as well as improvements in fatigue resistance (ie. endurance). Through testing and training we attempt to maximize both ends for peak performance.

The goal with training is two-fold: maximize your power output & resistance to fatigue, ie. endurance. The tricky part is, improvements in one usually results in the decrease in the other; and what gets tracked, gets trained.

Read More
The S:6 Testing Protocol, Part 1:

The S:6 Testing Protocol, Part 1:

  • October 24, 2017
  • Blog

There’s More to Power than Just FTP.

Before diving into another season of training on the bike, or jumping into serious training for the first time, it helps to know a few things about your current fitness as you get started…

  • Where is my fitness at right now? Identify a baseline from which you plan to improve.
  • What are the best ways to spend my training time? In order to maximize your improvement.
  • What effort levels should you should be training at? Set your training zones.

These insights can be found through power testing on the bike. For many years, a rider’s FTP (Functional Threshold Power) has been the focal point of where a rider’s fitness is and from what to set their training zones from. FTP works well. It shines light on one area of fitness and can be re-tested again and again to check for improvement.

By definition, your FTP is the power you could sustain for one hour, full gas. I say could sustain because who’s going to go all-out for an hour to find this value? So it’s become common place to go hard for 20-minutes and subtract 5% from your average power. Pretty much the Gold Standard, and everybody accepts it. Even going all-out for 20 minutes is pretty tough on your own, so more recent models are doing either one or two 8-minute intervals and subtracting 5-10% from those averages to estimate FTP. All said and done, these methods of FTP testing highlight one energy system (v02 max) and calculate the FTP from a “one size fits all” percent reduction from the test effort. From here, it doesn’t tell you much else. Does it work? Sure. However, if you’re like me, you would likely prefer more.

Read More